Hi Forum,
I would like to setup a bridge from my KNX house control over CueluxPro to DMX. A cue containing a RGB fade shall be dimmed by the house control.
On the KNX side an Eisbär server connects to the CueCore via Artnet. I can see the value moving on the CueCore webpage Monitor-Art-Net In A.
This value shall control the intensity of a cue. How shall I continue ? In the CueCore webpage or in CueLuxPro ? I have tried both, without success. The docu is very poor.
Assume I use the webpage:
I move to SHOW CONTROL, SOURCES Art-Net, Add >>, Enabled Yes.
On the right side: ACTION TYPE Action, << Add, Edit
TRIGGER TYPE: Channel, TRIGGER VALUE: Learn, Channel 8 is detected after moving the knx dimmer.
TRIGGER FLANK: Change, TASKS Add, but what now ? Console - Intensity - Control ?
I cannot get anything to work, even if my input signal seems to be detected correctly.
Assume I use the CueluxPro:
Memories - Action, Add Art-Net, Identifier Sub.Uni 2.2, Action Add, Trigger Learn does NOT work.
Is it necessary to enable the ArtNet In before ?
Questions over questions...
Regards
Axel