Visual Productions forum

Author Topic: API for UDP  (Read 4611 times)

September 30, 2013, 11:07:15 PM
Read 4611 times

jbh

  • Member
  • *
  • Posts: 1
Is there an special API or protocol for sending UDP to the CueCore.
I have read in the manual that I have to send a NULL terminated ascii string.
But it doesnt Work.
If I want to start an action, what is the complete mesage/string to send?

October 01, 2013, 09:17:29 AM
Reply #1

Dennis Kromhout

  • Member
  • *
  • Posts: 838
Hello,

There's no API or special protocol.
The trigger value in the CueCore needs to be the same as the string you're sending, thats all.

What are you using to send the UDP message?
Dennis Kromhout

April 07, 2015, 12:51:28 PM
Reply #2

ERC

  • Member
  • *
  • Posts: 35
  • Light Designer and Programmer
    • Architectural Light Design
Works great!

Little note: doesn't work on VLan at broadcast, you'll have to use a point to point, but then it works fine.

Likes to link everything that's possible... no is not the answer....

 

SMF spam blocked by CleanTalk